+86-571-88550927

How to use the resistance type remote pressure gauge correctly

Jun 04, 2021

How to use the resistance type remote pressure gauge correctly


The resistance type remote transmission pressure gauge is equipped with a variable sliding wire resistance (resistance transmitter) in the spring tube pressure gauge. When the measured pressure is introduced, the pointer of the shockproof pressure gauge can indicate the measured pressure on the spot. , At the same time, it drives the movable contact of the variable resistor to convert the change of the measured pressure value into the change of the resistance value, which is then displayed by the remote, centralized display instrument. YCD-150, YR-150 remote transmission pressure gauges belong to this type of pressure gauge. When using a resistance type remote pressure gauge, pay attention to the following issues.

0.000

1. The surface of movable contact and sliding wire resistance is easy to be contaminated or corroded. If dust enters the meter, the oval gear flowmeter will cause contact oxidation or poor contact, which will increase the contact resistance and affect the correct indication of the display meter. Therefore, prevent dust from entering the meter when using it. At the same time, it is necessary to do a good job of maintenance, scrub the resistance wire and contacts with alcohol.

2. The resistance pressure gauge is scaled with the display instrument, so it cannot be used interchangeably. If a certain part is damaged and needs to be replaced or the lateral pressure range is changed, it must be re-calibrated and scaled.

3. The resistance transmitter and the display instrument are connected by a wire, and a three-wire system is adopted for the connection. Because the resistance value of the connecting wire is a part of the bridge arm resistance displayed only, it has a direct influence on the indication, so the meter is marked with a certain external resistance on the scale panel when it leaves the factory. Explosion-proof electric contact pressure gauge Before using the instrument, the resistance of the connecting wire should be measured, and the resistance should be wound according to the regulations, and the external resistance value should be adjusted.



Send Inquiry