Instrumentation, including ceramic detector, thermal conductivity tester, expansion tester, material detection instrument, elastic modulus tester, etc., is used to detect, measure, observe, calculate a variety of physical quantities, material composition, physical parameters and other instruments or equipment. In order to be able to longer, more accurate use of it, we must maintain it.
Instrument appearance cleaning steps:
1. First wipe the surface of the instrument with a dry fine cotton cloth or wipe paper to wipe the dust or oil, and pay attention to the surface of the instrument to avoid injury.
2. Wipe the surface of the instrument, especially the metal and non-metal surface, with a clean, fine dry cotton cloth coated with industrial alcohol.
Instrument granite surface cleaning steps:
1. First wipe the granite surface with a dry fine cotton cloth or wipe paper to wipe the dust or oil stains left by the measuring parts.
2. Dip the industrial alcohol with a clean fine dry cotton cloth and wipe the outer surface of the granite. The alcohol is volatile and will evaporate naturally.
3. If necessary, you can use the special maintenance oil of granite to wipe it again.
Instrument mirror wipe steps:
1. Gently wipe the surface of the mirror with a mirror swab paper first, do not force to avoid damage to the mirror.
2. Then dip the cotton swab with industrial alcohol, gently wipe the surface of the mirror, and wait for the alcohol to evaporate before putting it back.
3. Mirror wipe can be divided into correction glass and lens group in the lens, because dust particles will cause imaging black spots, mirror wipe is very important, after the device need to re-observe the wipe results by image.
Transmission part of the instrument: dry friction part and lubrication part, dry friction part and the air bearing and toothless screw drive mechanism.
Dry friction part maintenance steps:
1. First use dry fine cotton cloth or wipe paper to wipe the friction surface, to wipe its dust or oil, etc.
2. You can also use a blow pot to blow off the dust.
3. When necessary, clean fine dry cotton cloth can be stained with industrial alcohol or advanced lubricating oil to wipe the friction surface.
Maintenance steps of lubrication part:
1. Wipe the dust off with a fine cotton cloth.
2. Add lubricating oil to the lubricating part, or add it with a butter gun
