Temperature transmitter precautions
The power supply of the temperature transmitter must not have spikes, otherwise it may easily damage the transmitter. The calibration of the transmitter should be carried out after 5 minutes of power on, and attention should be paid to the ambient temperature at that time. When measuring high temperatures (>100 ℃), filling materials should be used to isolate the sensor cavity from the junction box to prevent the transmitter from being burnt out due to high temperature in the junction box. When using sensors in severe interference situations, the casing should be firmly grounded to avoid interference, and the power supply and signal output should be Ф 10 shielded cable transmission, the crimping nut should be tightened to ensure airtightness. Only the RWB temperature transmitter has an output of 0-10mA, which is a three wire system and is below 5% of the range value. Due to the off characteristic of the transistor, it is not linear. The temperature transmitter should be calibrated every 6 months. If DWB cannot perform linear correction due to circuit limitations, it is best to select the range according to the instructions to ensure its linearity.
Reasons for inaccurate data display
1. Long circuit length and signal attenuation;
2. Line impedance mismatch;
3. The signal is disturbed and not shielded;







