Analysis of the reason why the dial was "bent"
When the pressure gauge was in use, the dial of some instruments was seriously deformed, and the thermal resistance required the manufacturer to go to the site to understand and deal with it.
It was indeed found on the scene that the dials of some meters were severely bent and deformed. The cover of this type of watch was rolled and overlocked. That is to say, if the cover was not destroyed, the cover would be a stainless steel pressure gauge that could not be opened from the outside. , This also ruled out the possibility of bending the dial, but what is the reason? The pressure gauge finally found the "answer" through the on-site understanding.
The gauge is an axial pressure gauge with edge. The thermal resistance is fixed on the installation panel of the instrument. The connector of the instrument is connected by a pipe. However, due to the design or downward slope of the pipe and the error in the forming, the axial direction of the pipe and the instrument is not Concentric, although the instrument can be installed by pushing the pipe by hand during installation, after the instrument is installed, the pipe will return to its "natural state" after the instrument is installed, and the connector of the instrument will be pulled into the stainless steel pressure gauge of the watch case. "Not at heart".
