Pressure gauge is composed of joint, spring tube, movement of several main components. Pressure gauge welding is mainly lead-zinc welding, silver welding, argon arc welding, special welding and so on, instrument clarinet normal work is 100,000 times. Its working principle is through the deformation of the spring tube, the movement (fan tooth and center gear work) to drive the pointer on the scale of the surface plate to display the measured medium pressure.
Three common problems in the use of pressure gauges:
1, pressure gauge fan gear working for a period of time will appear wear phenomenon;
2. The pressure measuring system of the pressure gauge is subjected to the instantaneous overpressure impact of the measured medium, so that the pointer can not return to zero or rush to the limit nail below;
3. Instrument pointer will not return to zero after system pressure relief.
Three solutions to common pressure gauge problems:
1, increase the width of the contact surface of the fan gear, increase the contact surface (that is, increase the modulus of the gear), in order to achieve the purpose of anti-wear and increase the service life;
2. Limit block is installed on the movement of the instrument. When the pressure measuring system is affected by the instantaneous impact, the cylindrical gear and fan gear of the movement are not easy to fall off, so as to solve the problem that the pointer does not return to zero or the pointer is rushed behind the limit nail after the pressure gauge is affected by the impact pressure;
3. Impact pressure measurement system Turn down the valve below the pressure gauge.






