+86-571-88550927

Contact Us

  • Factory: No.90 xinxin Rd, Fengdu industrial zone, Hangzhou, China.311115.
  • Office: Rm 707, 3# haloplaza, Liangzhu, Yuhang Dist, Hangzhou, China.
  • Jeffkf1502@163.com
  • Tel: +86-0571-88550927

  • Fax: +86-0571- 88550920

  • Wechat / Whatsapp: + 86 18758159121

Select The Quality Of The Pressure Gauge

Jan 30, 2023

1. The spring tube of general pressure gauge is a tubular spring with a certain cross section shape (flat circle and approximate ellipse are commonly used), bent into "C" shape, and can meet certain elastic requirements. If the spring tube is too small, the accuracy level of the pressure gauge will be affected.

2. If the indicated value of the pressure gauge exceeds the allowable error, the indicated value adjusting screw of the gauge should be adjusted. If the gauge does not have the indicated value adjusting screw, the gauge can only be judged as unqualified.

3. The indexing numbers and symbols on the dial of the pressure gauge shall be complete and clear. The dial graduation scale shall be evenly distributed, and the center angle of the package is generally 270 °. The pointer of the pressure gauge shall extend into the graduation line, and the width of its pointer indication end shall not be greater than 1/5 of the minimum graduation interval. The distance between the pointer and the plane of the indexing plate shall be within the range of 1~3mm, and the distance between the pointer and the plane of the indexing plate shall be within the range of 2~4mm if the outer diameter of the case is more than 200mm (including 200mm).

4. The gauge shell of the pressure gauge shall be able to protect the internal parts from pollution. The pressure gauge shall be equipped with a safety hole, and the safety hole shall be equipped with a dust-proof device.

5. For the pressure gauge with stop pin, the pointer shall be close to the stop pin when there is no pressure or vacuum, and the "shrinkage" shall not exceed the specified allowable error.

6. Digital pressure gauge. It depends on the rationality of the overall structure, the selected material, the aging process of electronic components, long-term stability, etc.

524

Send Inquiry